pena © 2014 by David Cook
The Warp Drive Effect produces a tunnel of streaking rectangles.|
Warp Drive produces its own colors but can also incorporate a bit of Color 1.
The Warp Drive Effect is time sensitive and can use a Clock or Clock Modifier (available in the Warp Drive Effect Options) to modify the Effect over time.
If you enable the Fit To Brush Option you will paint with the Warp Drive sized to your brush.
The Warp Drive Effect has the following Options Pane:|
|Clock:||This Effect can change over time. This control lets you select which of the four Clocks to use (Clocks are assigned in the Brush Pane). Any Green Colored Clock is the one currently in use. Tap the reset button and a Pop Up will appear that lets you reset any of the four Clocks to their initial value. Yellow colored clocks are not in use. Note that you can turn Clocks off by tapping a Green Clock turning all of them yellow.|
|Clock Modifier:||This value is added to the current Clock. You can use this to change where in time this Effect is, relative to the Clock (this allows different Effects to use the same Clock with different offsets).|
|X Zoom||This value sets the angle of the center hole in the X (horizontal) direction. This has the effect of zooming into the wall of the tunnel, or away from it.|
|Y Zoom||This value sets the angle of the center hole in the Y (vertical) direction. This has the effect of zooming into the wall of the tunnel, or away from it.|
|Warp Strength:||This value controls the strength of the warp effect. The smaller the value, the weaker the warp effect. The higher the value, the stronger the warp effect.|
|Brightness:||This value controls the brightness of the effect. The higher the value the brighter the effect.|
|Fit To Brush:||If set to a Red X the Effect spans the screen such that as you paint you reveal the Effect. When set to a Green Check Mark the Effect is sized to the brush such that as you paint the entire Effect is within the brush itself.|
|Output Color 1:||By default this is set to REPLACE which means that the set color will be output to Color 1. You can change this as explained in Options Pane Color Mixers.|
|Output Color 2:||By default this is set to IGNORE which means that the Color 2 will be ignored (the original Color 2 will be kept). You can change this as explained in Options Pane Color Mixers.|
The following image shows Super Nova with the default values. The yellow color is Color 1:|
In this next image Warp Strength has been brought near its minimum. See again how Color 1 is expressed as the yellow:
Here Warp Strength is near its maximum:
Finally we show X Zoom set to a large value allowing us to see the side of the warp wall:
Apple®, the Apple logo, iPad, iPad Air, iPad Mini, iPod, iPhone, and iTunes
are trademarks of Apple Inc., registered in the U.S. and other countries.
Wacom®, and Wacom Intuos Creative Stylus are trademarks of Wacom, registered in the U.S and other countries.